Keithley DMM7510 Reference Manual

Section
6: SCPI command reference Model DMM7510 7½ Digit Graphical Sampling Multimeter
Reference Manual
6-216 DMM7510-901-01 Rev. B / May 2015
Details
Sets the IP address for outgoing trigger events.
After you change this setting, you must send the connect command before outgoing messages can
be sent.
Example
TRIG:LAN1:OUT:IP:ADDR "192.0.32.10"
Use IP address
192.0.32.10
to connect the
LAN trigger.
Also see
:TRIGger:LAN<n>:OUT:CONNect:STATe (on page 6-215)
:TRIGger:LAN<n>:OUT:LOGic
This command sets the logic on which the trigger event detector and the output trigger generator operate on the
given trigger line.
Type Affected by Where saved Default value
Command and query
Recall settings
Instrument reset
Power cycle
Save settings
NEG
Usage
:TRIGger:LAN<n>:OUT:LOGic <logicType>
:TRIGger:LAN<n>:OUT:LOGic?
<n>
The LAN event number (1 to 8)
<logicType>
The type of logic:
• POSitive
•
NEGative
Example
TRIG:LAN1:OUT:LOG POS
Set the logic to positive.
Also see
None

Keithley DMM7510 Specifications

General

Resolution	7.5 digits
DC Voltage Range	100 mV to 1000 V
AC Voltage Range	100 mV to 750 V
DC Current Range	10 µA to 10 A
Resistance Range	10 Ω to 1 GΩ
Sampling Rate	1 MS/s
Memory	27.5 million readings
Display	5 inch capacitive touchscreen
AC Voltage Accuracy	±0.06% of reading
AC Current Range	10 A
Connectivity	USB, LAN, GPIB