Keithley DMM7510

Model DMM7510
7½ Digit Graphical Sampling Multimeter Reference Manual Section 8:
TSP command reference
DMM7510-901-01 Rev. B / May 2015 8-41
bufferVar.units
This attribute contains the unit of measure that is stored with readings in the reading buffer.
Type TSP-Link accessible Affected by Where saved Default value
Attribute (R) Yes
Restore configuration
Instrument reset
Power cycle
Not applicable Not applicable
Usage
readingUnit = bufferVar.units[N]
readingUnit
Volt DC: DC voltage measurement
Volt AC: AC voltage measurement
Amp DC: DC current measurement
Amp AC: AC current measurement
Ohm: Resistance measurement
Farad: Capacitance measurement
Hertz: Frequency measurement
Second: Period measurement
Ratio: DCV ratio measurement
%: Math is set to percent for the measurements
mX+b: Math is set to mx+b for the measurements
Reciprocal: Math is set to reciprocal for the measurements
Decibel: Units are set to decibel
Celsius: Temperature measurement
Kelvin: Temperature measurement
Fahrenheit: Temperature measurement
Watt DC
: Power measurement
bufferVar
The name of the reading buffer, which may be a default buffer (defbuffer1 or
defbuffer2) or a user-defined buffer
N
The reading number N; can be any value from 1 to the number of readings in the
buffer; use the bufferVar.n command to determine the number of readings in the
buffer