To Next Page

To Previous Page

Model DMM7510

7½ Digit Graphical Sampling Multimeter Reference Manual Section 6:

SCPI command reference

DMM7510-901-01 Rev. B / May 2015 6-25

Example

:CALC2:VOLT:LIM1:CLE:AUTO OFF

:CALC2:VOLT:LIM1:AUD FAIL

:CALC2:VOLT:LIM1:LOW 0.25

:CALC2:VOLT:LIM1:UPP 2.5

:CALC2:VOLT:LIMIT1:STAT ON

:READ?

:CALC2:VOLT:LIMIT1:FAIL?

:CALC2:VOLT:LIM1:CLE

Set limit autoclear off.

Enable the beeper for limit 1 when a voltage

measurement exceeds the limit.

Set lower limit 1 for voltage to 0.25 V.

Set upper limit 1 for voltage to 2.5 V.

Enable limit 1 testing for voltage.

Make a reading; the limit is checked and results

display on the front panel

Return the test results; example output if the test

fails on the low limit:

LOW

Clear the test results.

Also see

:CALCulate2:<function>:LIMit<Y>:CLEar:AUTO (on page 6-23)

:CALCulate2:<function>:LIMit<Y>:LOWer[:DATA] (on page 6-27)

:CALCulate2:<function>:LIMit<Y>:UPPer[:DATA] (on page 6-30)

Keithley DMM7510 Reference Manual

Other manuals for Keithley DMM7510