© 2018 MA Lighting Technology GmbH - Dachdeckerstr. 16 - 97297 Waldbüttelbrunn - Germany
Phone +49 5251 688865-27 - support@ma-dot2.com - www.malighting.com
1. Press Store and tap on the main executor in the executor bar view.
2. Tap Merge .
Figure 4: Values of cue 1 after store merge
The current programmer values are added to the existing cue 1.
Remove
Let´s assume, you will remove fixture ID 2 from the existing cue 1 on the main executor.
Figure 5: Values of cue 1 before store remove
1. Select fixture ID 2 in the fixtures view.
2. Double press Please . All values from fixture 2 are in the programmer.
3. Press Store Cue 1 and tap on the main executor in the executor bar view.
4. Tap Remove .
Figure 6: Values of cue 1 after store remove
The fixture ID 2 is removed from the existing cue 1 on the main executor.
Overwrite
Let´s assume, you will overwrite the cue 1 on the main executor with the current programmer values.
1. Press Store and tap on the main executor in the executor bar view.
2. Tap Overwrite .
Cue 1 on the main executor has now the current programmer values. All previous values from the existing cue
are deleted.
To Next Page
Loading...
