Planet WGSW-28040 - Ip Dhcp Snooping Verify

Command Guide of WGSW-28040
104
Default:
DHCP snooping trust is disabled
Mode:
Interface Configuration
Usage Guide:
Use the ip dhcp snooping trust command to set trusted interface. The switch does not check DHCP packets that
are received on the trusted interface; it simply forwards it. Use the no form of this command to set untrusted interface.
Example:
The example shows how to set interface gi1 to trust. You can verify settings by the following show ip dhcp snooping
interface command.
switch(config)# interface gi1
switch(config-if)# ip dhcp snooping trust
switch(config-if)# do show ip dhcp snooping interface gi1
Interfaces|Trust State|Rate (pps)|hwaddr Check|Insert Option82|
----------+-----------+----------+------------+---------------+
gi1 | Trusted | None | disabled | disabled |
4.6.4 ip dhcp snooping verify
Command:
ip dhcp snooping verify mac-address
no ip dhcp snooping verify mac-address
Default:
DHCP snooping verify mac-address is disabled
Mode:
Interface Configuration
Usage Guide:
Use the ip dhcp snooping verify command to verify MAC address function on interface.
The “mac-address” drop DHCP packets that chaddr and ethernet-source-mac is not match.
Example:
The example shows how to set interface gi1 to validate “mac-address”. You can verify settings by the following show
ip dhcp snooping interface command.