Planet WGSW-28040 - Ip Igmp Snooping Vlan

Command Guide of WGSW-28040
143
The configure can use ‘show ip igmp snooping querier’.
Example:
The following example specifies that set ip igmp snooping querier test.
Test must be create static vlan firstly.
Switch(config)# vlan 2
Switch(config-vlan)# exit
Switch(config)# ip igmp snooping vlan 2 querier
Switch(config)#exit
Switch#show ip igmp snooping querier
VID | State | Status | Version | Querier IP
-------+-------------+-------------+------------+--------------------
1 | Disabled | Non-Querier | No | ------
2 | Enabled | Querier | v2 | 192.168.1.254
Switch#configure
Switch(config)#ip igmp snooping version 3
Switch(config)# ip igmp snooping vlan 2 querier version 3
Switch(config)#do show ip igmp snooping queier
VID | State | Status | Version | Querier IP
-------+-------------+-------------+------------+--------------------
1 | Disabled | Non-Querier | No | ------
2 | Enabled | Querier | v3 | 192.168.1.254
Switch(config)#no ip igmp snooping queier
Switch(config)#do show ip igmp snooping queier
4.10.7 ip igmp snooping vlan
Command:
ip igmp snooping vlan VLAN-LIST
no ip igmp snooping vlan VLAN-LIST
Parameter:
VLAN-LIST
specifies VLAN ID list to set
Default: