To Next Page

To Previous Page

Command Guide of WGSW-28040

144

no ip igmp snooping vlan 1-4094

Mode:

Global Configuration

Usage Guide:

‘no ip igmp snooping vlan 1’ will clear vlan all ip igmp snooping dynamic group and dynamic router port, and make the

static ip igmp group invalid witch vlan ID is vlan 1. Then do not learning the dynamic group and router port by igmp

message for vlan 1.

The configure can use show ip igmp snooping vlan 1.

Example:

The following example specifies that set ip igmp snooping vlan test.

Test must be enable ip igmp snooping firstly.

Switch(config)# ip igmp snooping

Switch(config)# ip igmp snooping vlan 1

Switch# show ip igmp snooping vlan 1

IGMP Snooping is globaly enabled

IGMP Snooping VLAN 1 admin : enabled

IGMP Snooping operation mode : enabled

IGMP Snooping robustness: admin 2 oper 2

IGMP Snooping query interval: admin 125 sec oper 125 sec

IGMP Snooping query max response : admin 10 sec oper 10 sec

IGMP Snooping last member query counter: admin 2 oper 2

IGMP Snooping last member query interval: admin 1 sec oper 1 sec

IGMP Snooping last immediate leave: disabled

IGMP Snooping automatic learning of multicast router ports: enabled

Switch(config)# no ip igmp snooping vlan 1

Switch# show ip igmp snooping vlan 1

IGMP Snooping is globaly enabled

IGMP Snooping VLAN 1 admin : disabled

IGMP Snooping operation mode : disabled