Planet WGSW-28040 - Show Ipv6

Command Guide of WGSW-28040
98
Mode:
User EXEC
Privileged EXEC
Usage Guide:
Use “show ip dhcp” command to show IPv4 dhcp client enable state.
Example:
This example shows how to show current dhcp client state of the switch.
Switch# show ip dhcp
DHCP Status : enabled
4.4.38 show ipv6
Command:
show ipv6
Mode:
User EXEC
Privileged EXEC
Usage Guide:
Use “show ipv6” command to show system IPv6 address, net mask, default gateway and auto config state.
Example:
This example shows how to show current ipv6 address of the switch.
Switch# show ipv6
IPv6 DHCP Configuration : Disabled
IPv6 DHCP DUID :
IPv6 Auto Configuration : Enabled
IPv6 Link Local Address : fe80::dcad:beff:feef:102/64
IPv6 static Address : fe80::20e:2eff:fef1:4b3c/128
IPv6 static Gateway Address : ::
IPv6 in use Address : fe80::dcad:beff:feef:102/64
IPv6 in use Gateway Address : ::