Command Guide of WGSW-28040
271
Switch# show running-config
rate-limit ingress burst 5000
rate-limit egress burst 6000
rate-limit egress queue burst 7000
4.22.2 rate limit (interface)
Command:
rate-limit ingress <0-1000000>
no rate-limit ingress
rate-limit egress <0-1000000>
rate-limit egress queue <1-8> <0-1000000>
no rate-limit egress [<1-8>]
Parameter:
Cir
Specify the maximum number of kilobits per second of ingress traffic on a port. The
range is 100 –max port speed.
Specify the egress shaper queue number
Mode:
Interface Configuration
Usage Guide:
Use the rate-limit ingress Interface Configuration mode command to limit the incoming traffic rate on a port. Use the
no form of this command to disable the rate limit
Use the rate-limit egress Interface Configuration mode command to configure the egress port or queue shaper. Use
the no form of this command to disable the shaper
You can verify your setting by entering the show running-config interfaces Privileged EXEC command
Example:
The following example show how to configure ingress port rate limit and egress port & queue shaper.
Switch(config)# interfaces gi7
To Next Page
Loading...
Need help?
General