Planet WGSW-28040 - Show Gvrp Port Configuration

Command Guide of WGSW-28040
136
This command will display the gvrp global info.
Example:
The following example specifies that display gvrp test.
Switch# show gvrp
GVRP Status
--------------------
GVRP : Disabled
Join time : 200 ms
Leave time : 600 ms
LeaveAll time : 10000 ms
4.9.8 show gvrp port configuration
Command:
show gvrp configuration [interface IF_PORTS]
Parameter:
[interface
IF_PORTS]
Display Specifies posts configuration
Mode:
Privileged Configuration
Usage Guide:
This command will display the ports configuration info.
Example:
The following example specifies that display gvrp port configuration test.
Switch# show gvrp configuration
Port | GVRP-Status | Registration | Dynamic VLAN Creation
--------+---------------+---------------+----------------------
gi1 Disabled Normal Enabled
gi 2 Disabled Normal Enabled
gi 3 Disabled Normal Enabled
gi 4 Disabled Normal Enabled