Planet WGSW-28040 - Diagnostics

Command Guide of WGSW-28040
169
5 | --------- |
6 | --------- |
7 | --------- |
8 | --------- |
4.12.2 lacp system-priority
Command:
lacp system-priority <1-65535>
no lacp system-priority
Parameter:
<1-65535>
Specify system priority value
Default:
Default system priority is 1.
Mode:
Global Configuration
Usage Guide:
LACP system priority is used for two connected DUT to select master switch. Lower system priority value has higher
priority. And the DUT with higher priority can decide which ports are able to join the LAG.
Use “no lacp system-priority” to restore to the default priority value. The only way to show this configuration is using
“show running-config” command.
Example:
This example shows how to configure lacp system priority to 1000.
Switch(config)# lacp system-priority 1000
4.12.3 lacp port-priority
Command:
lacp port-priority <1-65535>