Planet WGSW-28040 - Ip Igmp Snooping Static Port; Ip Igmp Snooping Vlan Static Router Port

Command Guide of WGSW-28040
147
4.10.9 ip igmp snooping static port
Command:
[no] ip igmp snooping vlan <VLAN-LIST> static-port IF_PORTS
[no] ip igmp snooping vlan <VLAN-LIST> forbidden-port IF_PORTS
Parameter:
VLAN-LIST
specifies VLAN ID list to set
IF_PORTS
specifies a port list to set or remove
Default:
None static/forbidden ports
Mode:
Global Configuration
Usage Guide:
‘ip igmp snooping vlan 1 static-port gi1-2’ will add static port gi1-2 for vlan 1.the all known vlan 1 ipv4 group will add
the static ports.
‘ip igmp snooping vlan 1 forbidden-port gi3-4’ will add forbidden port gi3-4 for vlan 1.the all known vlan 1 ipv4 group
will remove the forbidden ports.
The configure can use ‘show ip igmp snooping forward-all’.
Example:
The following example specifies that set ip igmp snooping static/forbidden port test.
Switch(config)# ip igmp snooping vlan 1 static -port gi1-2
Switch(config)# ip igmp snooping vlan 1 forbidden -port gi3-4
Switch# show ip igmp snooping forward-all vlan 1
IGMP Snooping VLAN : 1
IGMP Snooping static port : gi1-2
IGMP Snooping forbidden port : gi3-4
4.10.10 ip igmp snooping vlan static router port
Command: