Planet WGSW-28040 - Spanning-Tree Mst Port-Priority

Command Guide of WGSW-28040
315
<0-15>
Specify the MST instance ID to configure.
<0-200000000>
Specify the STP port cost. In short pathcost method, the range is from 0 to 65535. ( 0 =
Auto )
Default:
spanning-tree mst = 0 ; cost = 0
Mode:
Port Configuration
Usage Guide:
This command configures the MSTP port cost for this MST instance. The configuration could be shown by “show
spanning-tree mst interface” command.
Example:
This example sets port gi1 STP pathcost of MST instance 1 to 100.
Switch# configure
Switch(config)# interface gi1
Switch(config-if)# spanning-tree mst 1 cost 100
4.26.20 spanning-tree mst port-priority
Command:
spanning-tree mst <0-15> priority <0-240>
Parameter:
<0-15>
Specify the MST instance ID to configure.
<0-240>
Specify the STP port priority. It must multiples of 16.
Default:
spanning-tree mst = 0; port-priority = 128
Mode:
Port Configuration
Usage Guide:
This command configures the MST port priority. The configuration could be shown by “show spanning-tree mst
interface” command.