Command Guide of WGSW-28040
76
4.4.13 ip address
Command:
ip address A.B.C.D [mask A.B.C.D]
Parameter:
Specify IPv4 address for switch
Specify net mask address for switch
Default:
Default IP address is 192.168.0.100 and default net mask is 255.255.255.0.
Mode:
Global Configuration
Usage Guide:
Use “ip address” command to modify administration ipv4 address. This address is very important. When we try to
use telnet, ssh, http, https, snmp… to connect to the switch, we need to use this ip address to access it.
Example:
This example shows how to modify the ipv4 address of the switch.
Switch(config)# ip address 192.168.1.200 mask 255.255.255.0
This example shows how to show current ipv4 address of the switch.
Switch# show ip
IP Address: 192.168.1.200
Subnet Netmask: 255.255.255.0
Default Gateway: 192.168.1.254
4.4.14 ip default-gateway
Command:
ip default-gateway A.B.C.D
To Next Page
Loading...
Need help?
General