EasyManuals Logo

Planet WGSW-28040 Command Guide

Planet WGSW-28040
351 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #186 background imageLoading...
Page #186 background image
Command Guide of WGSW-28040
186
Switch(config-if-range)# no lldp med tlv-select
Switch(config-if-range)# exit
Switch(config)# show lldp interfaces gi1-4 med
Port | Capabilities | Network Policy | Location | Inventory | POE
------ + ------------- + -------------- + -------- + ----------+ -----
gi1 | Yes | Yes | Yes | Yes | Yes
gi2 | Yes | Yes | Yes | Yes | Yes
gi3 | Yes | No | No | No | No
gi4 | Yes | No | No | No | No
4.13.13 lldp med fast-start-report-count
Command:
lldp med fast-start-repeat-count <1-10>
Parameter:
LLDP PDU fast start TX repeat counts.
Default:
lldp med fast-start-repeat-count 3
Mode:
Global Configuration
Usage Guide:
The command globally configures the LLDP PDU fast start TX repeat count. When port links up, it will send LLDP
PDU immediately to notify link partner. The number of LLDP PDU sends when it links up depends on
fast-start-repeat-count configuration. The LLDP PDU fast-start transmits in interval of one second. The fast start
behavior works no matter LLDP MED is enabled or not. The configuration could be shown by “show lldp med”
command.
Example:
This example sets fast start repeat count to 10.
Switch(config)# lldp med fast-start-repeat-count 10
Switch(config)# show lldp med
Fast Start Repeat Count: 10
lldp med network-policy voice: auto

Table of Contents

Other manuals for Planet WGSW-28040

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Planet WGSW-28040 and is the answer not in the manual?

Planet WGSW-28040 Specifications

General IconGeneral
BrandPlanet
ModelWGSW-28040
CategorySwitch
LanguageEnglish

Related product manuals