Command Guide of WGSW-28040
64
Global Configuration
Context Configuration
Usage Guide:
Use the show acl command to show created ACLs. You can specify mac、ip or ipv6 to show specific type ACL or
specify unique name string to show ACL with the name.
Example:
The example shows how to show all IP ACL.
Switch(config)# show ip acl
IP access list iptest
sequence 1 deny ip 192.168.1.80/255.255.255.255 any
4.3.11 show acl utilization
Command:
show all utilization
Mode:
Global Configuration
Usage Guide:
Use the show acl utilization command to show the usage of PIE of ASIC. When a ACL bind to interface, it needs
ASIC PIE resource to help to filter packet. An ASIC has limited PIE resource. This command help user to know the
PIE usage of AISC.
Example:
The example shows how to show PIE utilization
Switch(config)# show acl utilization
Group Index : 1
Group Assign to : Mac-based ACL and IPv4-based ACL
Group Maximun ACEs : 128
Group Remain ACEs : 125
Group Used ACEs : 3
ACEs Used by ACL : 3
ACEs Used by QoS : 0
------------------------------
To Next Page
Loading...
Need help?
General