Planet WGSW-28040 - Show Logging Flash | Buffered

Command Guide of WGSW-28040
207
Logging service is enabled
TARGET | STATUS | Server (PORT) | FACILITY | LOG LEVEL
----------+----------+---------------------------------+----------+----------------------------------
buffered | enabled | | |emerg, alert, crit, error, warning, notice, info
4.14.5 show logging flash | buffered
Command:
show logging (flash|buffered)
Parameter:
flash
Specify showing the messages logged to flash.
buffered
Specify showing the messages logged to RAM.
Mode:
Global Configuration
Privileged Configuration
Usage Guide:
Show the messages logged to flash/RAM.
show logging flash
Show the messages logged to the flash. When the capability of the service is enabled, it will show all message logged
to the flash. All messages will be logged in inverse chronological order.
show logging buffered
Show the messages logged to the RAM. When the capability of the service is enabled, it will show all message
logged to the RAM. Logs will be lost after system shutdown. All messages will be logged in inverse chronological
order.
Example:
Switch(config)# show logging buffered
Log messages in buffered
NO.| Timestamp | Category | Severity | Message
---------------------+----------------+----------+----------------------------------------
1| Jan 01 08:00:57| STP| info| Port 1 STP port state is set to Forwarding