Command Guide of WGSW-28040
257
4.21 QoS
4.21.1 qos
Command:
qos basic
Parameter:
Specify the device to qos basic mode
Mode:
Global Configuration
Usage Guide:
QoS have following 2 modes, use this command is able to switch between them.
Disable:
QoS function is disabled and all packets will go through lowest priority queue. It means first in will be first out, no QoS
is guarantee.
Basic:
According to basic trust type to assign queue for packets, and packets with higher priority are able to send first.
Example:
This example shows how to change qos to basic mode.
Switch(config)# qos basic
This example shows how to change qos to disabled mode.
Switch(config)# no qos
This example shows how to check current qos mode
To Next Page
Loading...
Need help?
General