Planet WGSW-28040 - Ip Dhcp Snooping Database Timeout

Command Guide of WGSW-28040
114
Type : tftp: 192.168.1.50
FileName : backup_file
Write delay Timer : 60 seconds
Abort Timer : 300 seconds
Agent Running : Running
Delay Timer Expiry : 300 seconds
Abort Timer Expiry : 299
Last Succeded Time : None
Last Failed Time : None
Last Failed Reason : No failure recorded.
Total Attempts : 1
Successful Transfers : 0 Failed Transfers : 0
Successful Reads : 0 Failed Reads : 0
Successful Writes : 0 Failed Writes : 0
4.6.17 ip dhcp snooping database timeout
Command:
ip dhcp snooping database timeout <0-86400>
no ip dhcp snooping database timeout
Parameter:
<0-86400>
specifies the seconds of timeout。Specify (in seconds) how long to wait for the database
transfer process to finish before stopping the process. Use 0 to define an infinite
duration, which means to continue trying the transfer indefinitely
Default:
DHCP snooping database timeout is 300 seconds
Mode:
Global Configuration
Usage Guide:
Use the ip dhcp snooping database timeout command to modify the timeout timer. Use the no form of this
command to default setting.
Example:
The example shows how to set timeout timer to 60 seconds. You can verify settings by the following show ip dhcp