Planet WGSW-28040 - Ip Dhcp Snooping Database Write-Deley

Command Guide of WGSW-28040
113
Agent Running : Running
Delay Timer Expiry : 300 seconds
Abort Timer Expiry : 299
Last Succeded Time : None
Last Failed Time : None
Last Failed Reason : No failure recorded.
Total Attempts : 1
Successful Transfers : 0 Failed Transfers : 0
Successful Reads : 0 Failed Reads : 0
Successful Writes : 0 Failed Writes : 0
4.6.16 ip dhcp snooping database write-deley
Command:
ip dhcp snooping database write-delay <15-86400>
no ip dhcp snooping database write-delay
Parameter:
<15-86400>
Specifies the seconds of timeout. Specify the duration for which the transfer should be
delayed after the binding database changes
Default:
DHCP snooping database write-delay is 300 seconds
Mode:
Global Configuration
Usage Guide:
Use the ip dhcp snooping database write-delay command to modify the write-delay timer. Use the no form of this
command to default setting.
Example:
The example shows how to set write-delay timer to 60 seconds. You can verify settings by the following show ip
dhcp snooping database command.
switch(config)# ip dhcp snooping database write-delay 60
switch(config)# do show ip dhcp snooping database