Planet WGSW-28040 - Port Error Disable; Errdisable Recovery Cause

Command Guide of WGSW-28040
243
4.19 Port Error Disable
4.19.1 errdisable recovery cause
Command:
errdisable recovery cause (all | acl | arp-inspection | broadcast-flood | bpduguard |
dhcp-rate-limit | psecure-violation | unicast-flood | udld | unknown-multicast-flood |
selfloop)
no errdisable recovery cause (all | acl | arp-inspection | broadcast-flood | bpduguard
| dhcp-rate-limit | psecure-violation | unicast-flood | udld | unknown-multicast-flood |
selfloop)
Parameter:
all
Enable/Disable to auto recovery for port error disabled by all reasons
acl
Enable/Disable to auto recovery for port error disabled
by ACL shutdown port reason.
arp-inspection
Enable/Disable to auto recovery for port error disabled by arp-inspection reason.
broadcast-flood
Enable/Disable to auto recovery for port error disabled by storm control broadcast flood
reason.
bpduguard
Enable/Disable to auto recovery for port error disabled by STP BPDU Guard reason.
dhcp-rate-limit
Enable/Disable to auto recovery for port error disabled by dhcp-rate-limit reason.
psecure-violation
Enable/Disable to auto recovery for port error disabled by violate port security rule
reason.
unicast-flood
Enable/Disable to auto recovery for port error disabled by storm control unicast flood
reason.
udld
Enable/Disable to auto recovery for port error disabled by udld reason.
unknown-multicast
-flood
Enable/Disable to auto recovery for port error disabled by storm control unknown
multicast flood reason.
selfloop
Enable/Disable to auto recovery for port error disabled by self loop detect reason.
Default:
Default auto recover state for all reasons are disabled.
Mode:
Global Configuration