Planet WGSW-28040 Command Guide

Command Guide of WGSW-28040
211
4.15.2 mac address-table aging-time
Command:
mac address-table aging-time <10-630>
Parameter:
<10-630>
Specify aging time value of second.
Default:
In default aging out time is 300s.
Mode:
Global Configuration
Usage Guide:
Use the mac address-table aging-time Global configuration command to set the aging time of the address table
You can verify your setting by entering the show mac address-table aging-time Privileged EXEC command
Example:
The following example show how to configure dynamic mac entry aging out time
Switch(config)# mac address-table aging-time 100
Switch# show mac address-table aging-time
Mac Address Table aging time: 100 sec
4.15.3 mac address-table static
Command:
mac address-table static A:B:C:D:E:F vlan <1-4094> interfaces IF_PORTS
no mac address-table static A:B:C:D:E:F vlan <1-4094>
Parameter:
A:B:C:D:E:F
Destination MAC address (unicast or multicast) to add to the address table. Packets
with this destination address received in the specified VLAN are forwarded to the
specified interface.
<1-4094>
Specify the VLAN for which the packet with the specified MAC address is received.

Planet WGSW-28040 Specifications

General

Brand	Planet
Model	WGSW-28040
Category	Switch
Language	English