Planet WGSW-28040 - Show Clock

Command Guide of WGSW-28040
328
Example:
The example shows how to set clock source of switch. You can verify settings by the following show show clock
command.
switch(config)# clock source sntp
switch(config)# show clock detail
08:32:12 test(UTC+5) Sep 21 2012
No time source
Time zone:
Acronym is DFL
Offset is UTC+8
4.28.5 show clock
Command:
show clock [detail]
Parameter:
detail
Show more detail information of clock
Mode:
Global Configuration
Usage Guide:
Use the show clock command to show clock of switch. The “detail” means that show more information of clock such
as time zone and daylight saving time.
Example:
The example shows how to show clock of switch and detail information.
Switch(config)# clock source sntp
Switch(config)# clock summer-time DLS recurring usa
Switch(config)# sntp host 192.168.1.100
Switch(config)# show clock
14:34:43 DLS(UTC+9) Sep 25 2012
Time source is sntp
Switch(config)# show clock detail