Planet WGSW-28040 - Snmp Access Group

Command Guide of WGSW-28040
285
Default:
Default View is “all” and subtree is .1 the type is include.
Mode:
Global Configuration
Usage Guide:
The default view can’t delete and create by user
The min view is sysUpTime.
The exclude view must in range of include view.otherwise, it is not invalid.
The configure use ‘show snmp view’ to check
Example:
The following example specifies that set view systemView test.
Switch(config)# snmp view systemView subtree 1.3.6.1.2.1.1 oid-mask all viewtype
included
Switch# show snmp view
View Name Subtree OID OID Mask View Type
--------------- -------------- ----------------- ----------------------
all .1 all included
systemView .1.3.6.1.2.1.1 all included
4.24.4 snmp access group
Command:
snmp group NAME version (1 |2c |3) (noauth | auth | priv) read-view NAME write-view
NAME [notify-view NAME]
no snmp group NAME security-mode version (1 |2c | 3)
Parameter:
NAME
Access group name
(1 |2c |3)
Access model for snmp v1/v2c/v3
(noauth | auth |
priv)
Noauth for snmp v1/v2c/v3
Auth and priv group for snmp v3
read-view NAME
Access group specifies read view
write-view NAME
Access group specifies write view
notify-view NAME
Access group specifies notify view