Planet WGSW-28040 - Ip Service

Command Guide of WGSW-28040
82
Example:
This example shows how to enable dhcp client.
Switch(config)# ipv6 dhcp
This example shows how to show current dhcpv6 client state of the switch.
Switch# show ipv6 dhcp
DHCPv6 Status : enabled
4.4.21 ip service
Command:
ip (telnet | ssh | http | https)
no ip (telnet | ssh | http | https)
Parameter:
telnet
Enable/Disable telnet service
Ssh
Enable/Disable ssh service
http
Enable/Disable http service
https
Enable/Disable https service
Default:
Default telnet service is disabled.
Default ssh service is disabled.
Default http service is enabled.
Default https service is disabled.
Mode:
Global Configuration
Usage Guide:
Use “ip service” command to enable all kinds of ip services. Such as telnet, ssh, http and https.
Use no form to disable service.
Example:
This example shows how to enable telnet service and show current telnet service status.