Planet WGSW-28040 - Dynamic ARP Inspection; Ip Arp Inspection; Ip Arp Inspection Vlan

Command Guide of WGSW-28040
124
4.8 Dynamic ARP Inspection
4.8.1 ip arp inspection
Command:
ip arp inspection
no ip arp inspection
Default:
Dynamic Arp inspection is disabled
Mode:
Global Configuration
Usage Guide:
Use the ip arp inspection command to enable Dynamic Arp Inspection function. Use the no form of this command to
disable.
Example:
The example shows how to enable Dynamic Arp Inspection on VLAN 1. You can verify settings by the following show
ip arp inspection command.
switch(config)# ip arp inspection
switch(config)# ip arp inspection vlan 1
switch(config)# show ip arp inspection
Dynamic ARP Inspection : enabled
Enable on Vlans : 1
4.8.2 ip arp inspection vlan
Command:
ip arp inspection vlan VLAN-LIST
no ip arp inspection vlan VLAN-LIST
Parameter: