Planet WGSW-28040 - Show Ip Igmp Port Max-Group Action

Command Guide of WGSW-28040
162
Switch(config-if)#ip igmp max-groups 50
Switch(config-if)#exit
Switch(config)#exit
Switch# show ip igmp max-group
Port ID | Max Group
---------+--------------
gi1 : 50
gi2 : 256
gi3 : 256
gi4 : 256
gi5 : 256
--More--
4.10.27 show ip igmp port max-group action
Command:
show ip igmp max-group action [interfaces IF_PORTS]
Parameter:
[interfaces
IF_PORTS]
Show specifies ports max-group action
Mode:
Privileged Configuration
Usage Guide:
This command will display ip igmp port max-group action.
Example:
The following example specifies that show ip igmp max-group action test.
Switch(config)#interface gi1
Switch(config-if)#ip igmp max-groups action replace
Switch(config-if)#exit
Switch(config)#exit
Switch# show ip igmp max-group action
Port ID | Max-groups Action