Command Guide of WGSW-28040
350
voice-vlan
Mode:
Interface Configuration
Usage Guide:
Use the voice vlan Interface configuration command to enable OUI voice VLAN configuration on an interface
Use the no form of this command to disable voice vlan on an interfaces
You can verify your setting by entering the show voice vlan Privileged EXEC command
Example:
The following example how to enable voice VLAN function in oui mode on an interface
Switch(config)#interface range gi1-3
Switch(config-if)#voice-vlan
4.30.8 show voice vlan
Command:
show voice-vlan
show voice-vlan interfaces IF_PORTS
Parameter:
Specifies intefaces to display voice VLAN settings in oui mode
Mode:
Privileged EXEC
Usage Guide:
Use the show voice vlan command in EXEC mode to display the voice VLAN status for all interfaces or for a specific
interface if the voice VLAN type is OUI
Example:
The following example show how to display voice vlan auto mode and oui mode settings
To Next Page
Loading...
Need help?
General