Planet WGSW-28040 - Show Dot1 X Guest-Vlan

Command Guide of WGSW-28040
33
Command:
show dot1x interface IF_PORTS
Parameter:
IF_PORTS
Select port to show dot1x configurations.
Mode:
Privileged EXEC
Usage Guide:
Use “show dot1x interfaces” command to show dot1x information of the specified port.
Example:
This example shows how to show dot1x configurations on interface gi1.
Switch# show dot1x interfaces gi1
Port | Mode | Current State | Reauth Control | Reauth Period
--------+--------------------+----------------------+-----------------+--------------
gi1 | 802.1X Disabled | - | Enabled | 3600
Quiet Period: 60 Second
Supplicant timeout: 30 Second
Max req: 2
Session Time (HH:MM:SS): 0: 0: 0: 0
4.1.13 show dot1x guest-vlan
Command:
show dot1x guest-vlan
Mode:
Privileged EXEC
Usage Guide:
Use “show dot1x guest-vlan” command to show dot1x guest-vlan status.
Example:
This example shows how to show the dot1x guest-vlan status.