Planet WGSW-28040 - Switchport Trunk Allowed Vlan; Switchport Default-Vlan Tagged

Command Guide of WGSW-28040
338
Example:
This example sets Trunk port gi10 native VLAN to 100.
Switch# configure
Switch(config)# interface gi10
Switch(config-if)# switchport mode trunk
Switch(config-if)# switchport trunk native vlan 100
4.29.12 switchport trunk allowed vlan
Command:
switchport trunk allowed vlan ( add | remove ) ( VLAN-LIST | all )
Parameter:
( add | remove )
Specify the action to add or remove the allowed VLAN list.
( VLAN-LIST | all )
Specify the VLAN list or all VLANs to be added or removed.
Mode:
Port Configuration
Usage Guide:
The command per Trunk port configures the allowed VLAN list. The configuration could be shown by “show interface
switchport” command.
Example:
This example sets Trunk port gi10 to add the allowed VLAN 100.
Switch# configure
Switch(config)# interface gi10
Switch(config-if)# switchport trunk allowed vlan add 100
4.29.13 switchport default-vlan tagged
Command: