Planet WGSW-28040 - Link Aggregation

Command Guide of WGSW-28040
79
Switch# show ip dhcp
DHCP Status : enabled
4.4.17 ipv6 autoconfig
Command:
ipv6 autoconfig
no ipv6 autoconfig
Default:
Default IPv6 auto config is enabled.
Mode:
Global Configuration
Usage Guide:
Use “ipv6 autoconfig” command to enabled IPv6 auto configuration feature.
Use “no ipv6 autoconfig” command to disabled IPv6 auto configuration feature.
Example:
This example shows how to disable IPv6 auto config.
Switch(config)# no ipv6 autoconfig
This example shows how to show current IPv6 auto config state.
Switch# show ipv6
IPv6 DHCP Configuration : Disabled
IPv6 DHCP DUID :
IPv6 Auto Configuration : Disabled
IPv6 Link Local Address : fe80::dcad:beff:feef:102/64
IPv6 static Address : fe80::20e:2eff:fef1:4b3c/128
IPv6 static Gateway Address : ::
IPv6 in use Address : fe80::dcad:beff:feef:102/64
IPv6 in use Gateway Address : ::