Planet WGSW-28040 - Show Ip Dhcp Snooping Interface

Command Guide of WGSW-28040
107
Example:
The example shows how to show settings of DHCP Snooping
switch(config)# show ip dhcp snooping
DHCP Snooping : enabled
Enable on following Vlans : 1
circuit-id default format: vlan-port
remote-id: : 00:11:22:33:44:55 (Switch Mac in Byte Order)
4.6.8 show ip dhcp snooping interface
Command:
show ip dhcp snooping interfaces IF_PORTS
no show ip dhcp snooping interfaces IF_PORTS
Parameter:
IF_PORTS
specifies ports to show statistics
Mode:
Global Configuration
Usage Guide:
Use the show ip dhcp snooping interfaces command to show settings or statistics of interface.
Example:
The example shows how to show settings of interface gi1.
switch# show ip dhcp snooping interface gi1
Interfaces | Trust State | Rate (pps) | hwaddr Check | Insert Option82 |
------------+--------------+-------------+-------------------+-------------------+
gi1 | Untrusted | None | enabled | disabled |
The example shows how to show statistics of interface gi1.
switch# show ip dhcp snooping interfaces gi1 statistics
Interfaces | Forwarded | Chaddr Check Dropped | Untrust Port Dropped | Untrust Port With