Planet WGSW-28040 - Dot1 X Timeout Reauth-Period

Command Guide of WGSW-28040
25
Max req: 2
Session Time (HH:MM:SS): 0: 0: 0: 0
4.1.4 dot1x timeout reauth-period
Command:
dot1x timeout reauth-period <30-65535>
no dot1x timeout reauth-period
Parameter:
<30-65535>
Specify the re-authentication period.
Default:
3600 seconds
Mode:
Interface Configuration
Usage Guide:
Use the “dot1x timeout reauth-period” command to configure the re-authentication period. Use the no form of this
command to restore the period to default value.
Example:
The example shows how to configure re-authentication period to 300 sec. on port 1.
switch(config)# interface gi1
switch(config-if)# dot1x timeout reauth-period 300
switch(config-if)# exit
switch(config)# show dot1x interfaces gi1
Port | Mode | Current State | Reauth Control | Reauth Period
--------+--------------------+----------------------+---------------------+-----------------
gi1 Authentication | Initialize | Enabled | 300
Quiet Period: 60 Second
Supplicant timeout: 30 Second
Max req: 2
Session Time (HH:MM:SS): 0: 0: 0: 0