Planet WGSW-28040 - Snmp View

Command Guide of WGSW-28040
284
snmp trap port-security
Mode:
Global Configuration
Usage Guide:
‘no snmp trap auth’ snmp will not send auth failure trap.
‘no snmp trap linkUpDown’ snmp will not send linkup and link down trap.
‘no snmp trap warm-start snmp will not send warm start trap.
‘no snmp trap cold-start’ snmp will not send cold start trap.
‘no snmp trap port-security’ snmp will not send port-security trap.
The configure can use show snmp trap.
Example:
The following example specifies that set trap auth disable test.
Switch(config)#no snmp auth
Switch# show snmp trap
SNMP auth failed trap : Disable
SNMP linkUpDown trap : Enable
SNMP warm-start trap : Enable
SNMP cold-start trap : Enable
SNMP port security trap: Enable
4.24.3 snmp view
Command:
snmp view NAME subtree OID oid-mask (all | MASK) viewtype (included | excluded)
no snmp view NAME subtree (all |OID)
Parameter:
NAME
View Name
OID
View subtree OID
(all | MASK)
View subtree OID mask.
All: all mask bit is ‘1’
(included |
excluded)
View subtree is accessed or not allowed accesse
(all |OID)
Delete the View name all subtree OID or specifies OID