Planet WGSW-28040 - Speed

Command Guide of WGSW-28040
248
4.20.2 speed
Command:
speed (10 | 100 | 1000)
speed auto [(10 | 100 | 1000 | 10/100)]
Parameter:
10
Specify port speed to force 10Mbits/s or auto with 10Mbits/s ability.
100
Specify port speed to force 100Mbits/s or auto with 100Mbits/s ability.
1000
Specify port speed to force 1000Mbits/s or auto with 1000Mbits/s ability.
10/100
Specify port speed to auto with 10Mbits/s and 100Mbits/s
Default:
Default port speed is auto with all available abilities.
Mode:
Interface Configuration
Usage Guide:
Use “speed” command to change port speed configuration. The speed is only able to configure to the physical
maximum speed. For example, in fast Ethernet port, speed 1000 is not available.
Example:
This example shows how to modify port speed configuration.
Switch(config)# interface gi1
Switch(config-if)# speed 100
Switch(config-if)# exit
Switch(config)# interface gi2
Switch(config-if)# speed auto 10/100
This example shows how to show current speed configuration
Switch# show running-config interfaces gi1-2
interface gi1
speed 100
interface gi2
speed auto 10/100