Planet WGSW-28040 - Dot1 X Max-Req

Command Guide of WGSW-28040
27
dot1x timeout supp-timeout <1-65535>
no dot1x timeout supp-timeout
Parameter:
<1-65535>
Specify the supplicant period.
Default:
30 seconds
Mode:
Interface Configuration
Usage Guide:
Use the “dot1x timeout supp-timeout” command to configure the supplicant period. Use the no form of this
command to restore the period to default value.
Example:
The example shows how to configure supplicant period to 300 sec. on port 1.
switch(config)# interface gi1
switch(config-if)# dot1x timeout supp-timeout 300
switch(config-if)# exit
switch(config)# show dot1x interfaces gi1
Port | Mode | Current State | Reauth Control | Reauth Period
--------+--------------------+----------------------+---------------------+-----------------
gi1 Authentication | Initialize | Enabled | 3600
Quiet Period: 60 Second
Supplicant timeout: 300 Second
Max req: 2
Session Time (HH:MM:SS): 0: 0: 0: 0
4.1.7 dot1x max-req
Command:
dot1x max-req <1-10>
no dot1x max-req