Planet WGSW-28040 - Snmp; Snmp Trap

Command Guide of WGSW-28040
283
4.24 SNMP
4.24.1 snmp
Command:
snmp
no snmp
Mode:
Global Configuration
Usage Guide:
‘no snmp’ will disable snmp.
‘snmp’ will enable snmp.
The configure can use show snmp
Example:
The following example specifies that set global snmp test
Switch(config)# snmp
Switch# show snmp
SNMP is enabled
4.24.2 snmp trap
Command:
[no] snmp trap (auth|linkUpDown|warm-start|cold-start|port-security)
Default:
snmp trap auth
snmp trap linkUpDown
snmp trap warm-start
snmp trap cold-start