Planet WGSW-28040 - Ip Igmp Snooping Querier

Command Guide of WGSW-28040
142
Mode:
Global Configuration
Usage Guide:
When change lookup method, it will remove all groups.
The configure can use ‘show ip igmp snooping’.
Example:
The following example specifies that set ip igmp lookup method is src-dst-ip test.
Switch(config)# aaa authentication login test1 tacacs+ radius local
Switch(config)# ip igmp forward-method src-dst-ip
Switch# show ip igmp snooping
IGMP Snooping Status
--------------------
Snooping : Disabled
Report Suppression : Disabled
Operation Version : v2
Forward Method : src-dst-ip
4.10.6 ip igmp snooping querier
Command:
ip igmp snooping vlan <VLAN-LIST> querier
no ip igmp snooping [vlan <VLAN-LIST>] querier
ip igmp snooping vlan <VLAN-LIST> querier version (2|3)
Parameter:
<VLAN-LIST>
specifies VLAN ID list to set
(2|3)
Query version 2 or 3
Mode:
Global Configuration
Usage Guide:
When enable ip igmp vlan querier, there will process router select, the select successful will send general and specific
query.