Planet WGSW-28040 - Lldp Tlv-Select Pvid

Command Guide of WGSW-28040
179
Hold multiplier: 3
Reinit delay: 2 Seconds
Tx delay: 2 Seconds
LLDP packet handling: Flooding
Port | State | Optional TLVs | Address
-------- + ------ + -------------- + --------
gi1 | RX,TX | PD, SN, SD, SC |192.168.1.254
gi3 | RX,TX | PD, SN, SD, SC |192.168.1.254
Port ID: gi1
802.3 optional TLVs: 802.3-mac-phy, 802.3-lag, 802.3-max-frame-size, management-addr
802.1 optional TLVs
PVID: Enabled
Port ID: gi3
802.3 optional TLVs: 802.3-mac-phy, 802.3-lag, 802.3-max-frame-size, management-addr
802.1 optional TLVs
PVID: Enabled
4.13.7 lldp tlv-select pvid
Command:
lldp tlv-select pvid (disable|enable)
Parameter:
(disable|enable)
Specifies the LLDP 802.1 PVID TLV attach enable status.
Default:
lldp tlv-select pvid enable
Mode:
Interface Configuration
Usage Guide:
This command per port configures the 802.1 PVID TLV attach enable status. The configuration could be shown by
“show lldp” command.
Example:
This example sets port gi1 PVID TLV attach status to disable and port gi2 to enable.