Planet WGSW-28040 - Interface

Command Guide of WGSW-28040
68
Mode:
Privileged EXEC
Usage Guide:
Use “configure” command to enter global configuration mode. In global configuration mode, the prompt will show as
“Switch(config)#”.
Example:
This example shows how to enter global configuration mode.
Switch# configure
Switch(config)#
4.4.4 interface
Command:
interface IF_PORTS
interface range IF_PORTS
Parameter:
IF_PORTS
Specify
the port to select. This parameter allows partial port name and ignore case. For
Example:
Gigabit4
......
If port range is specified, the list format is also available. For Example:
gi1-3
......
Mode:
Global Configuration
Usage Guide:
Some configurations are port based. In order to configure these configurations, we need to enter Interface
Configuration mode to configure them. Use “interface” command to enter the Interface Configuration mode and
select the port to be configured.
In Interface Configuration mode, the prompt will show as “Switch(config-if)#”
Example:
This example shows how to enter Interface Configuration mode