Planet WGSW-28040 - Dot1 X Reauthentication

Command Guide of WGSW-28040
24
gi1 Authentication | Initialize | Enabled | 3600
Quiet Period: 60 Second
Supplicant timeout: 30 Second
Max req: 2
Session Time (HH:MM:SS): 0: 0: 0: 0
4.1.3 dot1x reauthentication
Command:
dot1x reauth
no dot1x reauth
Default:
Default is disabled
Mode:
Interface Configuration
Usage Guide:
Use the “dot1x reauth” command to enable 802.1X periodical reauthentication function on port. Use the no form of
this command to disable this function.
Example:
The following example shows how to enable 802.1X access control on port 1.
switch(config)# interface gi1
switch(config-if)# dot1x reauth
switch(config-if)# exit
switch(config)# show dot1x
802.1x protocol is: Enabled
802.1x protocol version: 2
switch(config)# show dot1x interfaces gi1
Port | Mode | Current State | Reauth Control | Reauth Period
--------+--------------------+----------------------+---------------------+-----------------
gi1 Authentication | Initialize | Enabled | 3600
Quiet Period: 60 Second
Supplicant timeout: 30 Second