Planet WGSW-28040 - Voice Vlan Cos Mode; Voice Vlan Enable

Command Guide of WGSW-28040
349
Example:
The following example show how to set aging time.
Switch(config)# voice-vlan aging-time 720
4.30.6 voice vlan cos mode
Command:
voice-vlan cos ( src | all )
no voice-vlan
Parameter:
src
Specify QoS attributes are applied to packets with OUIs in the source MAC address.
all
Specify QoS attributes are applied to packets that are classified to the Voice VLAN.
Default:
The defaultall port in Src mode.
Mode:
Interface Configuration
Usage Guide:
Use the voice vlan cos mode Interface configuration command to configure OUI voice VLAN cos mode
configuration on an interface
You can verify your setting by entering the show voice vlan interfaces Privileged EXEC command
Example:
The following example how to configure voice packet QoS attributes on an interface
Switch(config)#interface range gi1-3
Switch(config-if)#voice-vlan cos all
4.30.7 voice vlan enable
Command: