Planet WGSW-28040 - Switchport Access Vlan

Command Guide of WGSW-28040
336
switchport hybrid allowed vlan remove VLAN-LIST
Parameter:
VLAN-LIST
Specifies the VLAN list to be removed.
Mode:
Port Configuration
Usage Guide:
This command per hybrid port configures to remove the allowed VLAN list. The configuration could be shown by
“show interface switchport” command.
Example:
This example sets port fa10 VLAN to leave the VLAN 100.
Switch# configure
Switch(config)# interface gi10
Switch(config-if)# switchport hybrid allowed vlan remove 100
4.29.9 switchport access vlan
Command:
switchport access vlan <1-4094>
Parameter:
<1-4094>
Specifies the access VLAN ID.
Mode:
Port Configuration
Usage Guide:
This command per Access port configures the native VLAN ID. The configuration could be shown by “show interface
switchport” command
Example:
This example sets Access port fa10 native VLAN ID to 100.
Switch# configure
Switch(config)# interface gi10