Planet WGSW-28040 - Restore-Default; Show Config

Command Guide of WGSW-28040
321
This example shows how to delete backup firmware image from flash.
Switch# delete system image1
4.27.5 restore-default
Command:
restore-default
Mode:
Privileged EXEC
Usage Guide:
Use “restore-defaults” command to restore factory default of all system. The command is equal to “delete
startup-config”
Example:
This example shows how to restore factory defaults.
Switch# restore-defaults
Restore Default Success. Do you want to reboot now? (y/n)n
4.27.6 show config
Command:
show (running-config | startrup-config | backup-config)
Parameter:
running-config
Show running configuration on terminal
startrup-config
Show startup configuration on terminal
backup-config
Show backup configuration on terminal
Mode:
Privileged EXEC