Planet WGSW-28040 - Clear Gvrp Statistics; Show Gvrp Statistics

Command Guide of WGSW-28040
134
Port | GVRP-Status | Registration | Dynamic VLAN Creation
--------+---------------+---------------+----------------------
gi1 Enabled Normal Disabled
4.9.5 clear gvrp statistics
Command:
clear gvrp (error-statistics | statistics) [interfaces IF_PORTS]
Parameter:
(error-statistics |
statistics)
Error-statistics: error gvrp packet statistics
Statistics: gvrp event message statistics
[interfaces
IF_PORTS]
Specifies posts to clear statistics
Mode:
Privileged Configuration
Usage Guide:
This command will clear the ports error statistics or statistics info.
The configure can use ‘show gvrp error-statistics or show gvrp statistics’ to check.
Example:
The following example specifies that clear gvrp error statistics and statistics test.
Switch# clear gvrp statistics
Switch# clear gvrp error-statistics
Switch# show gvrp statistics
Switch# show gvrp error-statistics
4.9.6 show gvrp statistics
Command:
show gvrp statistics [interfaces IF_PORTS]