Planet WGSW-28040 - Show Ipv6 Dhcp; Show Line

Command Guide of WGSW-28040
99
4.4.39 show ipv6 dhcp
Command:
show ipv6 dhcp
Mode:
User EXEC
Privileged EXEC
Usage Guide:
Use “show ipv6 dhcp” command to show system IPv6 dhcp client enable state.
Example:
This example shows how to show current dhcpv6 client state of the switch.
Switch# show ipv6 dhcp
DHCPv6 Status : enabled
4.4.40 show line
Command:
show line [(console | telnet | ssh)]
Parameter:
console
Select console line to show.
telnet
Select telnet line to show.
ssh
Select ssh line to show.
Mode:
Privileged EXEC
Usage Guide:
Use “show line” command to show all line configurations including session timeout, history count, password retry
number and silent time. For telnet and ssh, it also shows the service enable/disable state.