Command Guide of WGSW-28040
75
Switch# show username
Priv | Type | User Name | Password
------+--------+--------------------+------------------------
01 | secret | | dnXencJRwflV6
15 | secret | admin | FzjrGO6vfbERY
15 | secret | test | 7p57T9yMkViSUS
4.4.12 enable password
Command:
enable [privilege <0-15>] (password | secret) WORD<0-32>
no enable [privilege <0-15>]
Parameter:
Specify the privilege level to configure. If no privilege level is specified, default is 15.
password
Specify password string and make it not encrypted.
secret
Specify password string and make it encrypted.
Default:
Default enable password for all privilege levels are “”.
Mode:
Global Configuration
Usage Guide:
Use “enable password” command to edit password for each privilege level for enable authentication. And use “no
enable” command to restore enable password to default empty value.
The only way to show this configuration is using “show running-config” command.
Example:
This example shows how to edit enable password for privilege level 15
Switch(config)# enable secret enblpasswd
To Next Page
Loading...
Need help?
General