Command Guide of WGSW-28040
170
Parameter:
Specify port priority value
Default:
Default port priority is 1.
Mode:
Interface Configuration
Usage Guide:
LACP port priority is used for two connected DUT to select aggregation ports. Lower port priority value has higher
priority. And the port with higher priority will be selected into LAG first.
The only way to show this configuration is using “show running-config” command.
Example:
This example shows how to configure interface fa1 lacp port priority to 100.
Switch(config)# interface gi1
Switch(config-if)# lacp port-priority 100
4.12.4 lacp timeout
Command:
lacp timeout (long | short)
Parameter:
Send LACP packet every 30 seconds.
Send LACP packet every 1 seconds.
Default:
Default LACP timeout is long.
Mode:
Interface Configuration
Usage Guide:
LACP need to send LACP packet to partner switch to check the link status. This command configure the interval of
sending LACP packets.
The only way to show this configuration is using “show running-config” command.
To Next Page
Loading...
Need help?
General