Planet WGSW-28040 - Show Qos

Command Guide of WGSW-28040
266
Parameter:
cos
Enable/Disable cos remarking.
dscp
Enable/Disable dscp remarking.
precedence
Enable/Disable precedence remarking.
Default:
Default CoS remarking is disabled.
Default DSCP remarking is disabled.
Default IP Precedence remarking is disabled.
Mode:
Interface Configuration
Usage Guide:
QoS remarking feature allow you to change priority information in packets based on egress queue. For example, you
want all packets egress from interface fa1 queue 1 to remark the cos value to be 5 for next tier of device, you can
enable the cos remarking feature on fa1 and configure the queue-cos map for queue 1 map to cos 5.
Use “qos remark” command to enable remarking feature on specific type. And use “no qow remark” command to
disable it.
Example:
This example shows how to enable remarking features on interface gi1.
Switch(config)# interface GigabitEthernet 1
Switch(config-if)# qos remark cos
Switch(config-if)# qos remark dscp
Switch(config-if)# qos remark precedence
Switch(config-if)# end
Switch# show qos interface GigabitEthernet 1
Port | CoS | Trust State | Remark Cos | Remark DSCP | Remark IP Prec
--------+-------+---------------+------------+-------------+----------------
gi1 | 0 | enabled | enabled | enabled | enabled
4.21.8 show qos
Command:
show qos