Planet WGSW-28040 - Ipv6 Mld Filter

Command Guide of WGSW-28040
228
IPv6 mld profile index: 5
IPv6 mld profile action: deny
Range low ip: ff12::1
Range high ip: ff12::12
Switch(config-mld-profile)#exit
Switch(config)# exit
Switch# show ipv6 mld profile
IPv6 mld profile index: 1
IPv6 mld profile action: permit
Range low ip: ff13::1
Range high ip: ff13::10
IPv6 mld profile index: 5
IPv6 mld profile action: deny
Range low ip: ff12::1
Range high ip: ff12::12
4.17.10 ipv6 mld filter
Command:
ipv6 mld profile <1-128>
profile range ipv6 <ipv6-addr> [ipv6-addr] action (permit | deny)
show ipv6 mld profile [<1-128>]
Parameter:
<1-128>
specifies profile ID
[interfaces
IF_PORTS]
Specifies interfaces to display
Mode:
Interface mode
Usage Guide:
After create ipv6 mld profile entry. Can use ‘ipv6 mld filter 1’ to bind a profile for port.
When then port bind a profile. Then the port learning group will update, if the group is not match the profile rule it will
remove the port from the group. Static group is excluded.